MODEL- GT701A VENDOR- ACTIONTEC ELECTRONICS FEATURES- USB/Ethernet DSL Modem with Routing Capabilities The Actiontec USB/Ethernet DSL Modem with Routing Capabilities is really two devices rolled into one. It is a full rate ADSL modem that is upgradeable to the new, faster ADSL 2/2+protocol. And It is a router, capable of networking up to two computers, via wired ports, with a minimum amount of hassle. So, get rid of the clutter of components on your desk and replace them all with the Actiontec USB/Ethernet DSL Modem with Routing Capabilities. The Modems engine is ready for the future. It can be upgraded to ADSL2, the new DSL standard that enhances modem performance by tripling the available bandwidth (from 8 Mbps to 24 Mbps). Say goodbye to stuttering, pixilated video streams and the endless wait while downloading large files. There is more room for voice data, as well, so you can experience free or low-cost Internet telephone conversations. And since the upgrade to ADSL2 can be done remotely, you will not need a Ph.D to get yourself up to speed. The DSL Modem includes TIs TNETD7300 Broadband Communication Processor and Peripherals. The TNETD7300 is the industry s most densely integrated system-on-a-chip ever offered to the ADSL CPE market by Texas Instruments. The TNETD7300 is considered an ADSL bridge/router solution, integrating a broadband communications processor and peripherals, ADSL physical layer, ADSL line driver, USB physical layer, and Ethernet physical layer. * Supports UPnP Plug-and-Play installation for systems with Windows Operating Systems (98, 98SE, Me, 2000 and XP). * Support One ADSL WAN port (RJ11) * Compliant with full-rate ANSI T1.413 Issue 2, ITU G.992.1 (G.dmt) and G.992.2 (G.lite) standard. * Auto-handshake for different ADSL flavors * Compliant with USB 1.1 device specification * Supports 12-Mbits/s USB data rate (Full Speed) * Bridged Ethernet over ATM, PPP over ATM, PPP over Ethernet * Precise ATM traffic shaping * IP packet routing and transparent bridge * Routing protocol supports RIP-1, RIP-2, Static Routing * Build-in NAT, DHCP server * DNS relay support * PAP/CHAP authentication, administrative passwords through Telnet * Compliant with IEEE 802.3 Ethernet standard * Supports One 10/100 Base-T Ethernet LAN port * Flow control support for Fast Ethernet * Web-based configuration setup * Default configuration backup restore * FTP firmware upgradeable * Support web download -- SPECIFICATIONs ------------------------------------ STANDARDS - ADSL: ITU G.992.1 (G.dmt), G.992.2 (G.Lite), G.992.3 (G.dmt.bis), G.992.5 (ADSL2plus) G.992.4 (G.lite.bus), G.994.1 (G.hs) ANSI: T1.413 Issue 2 (available in future firmware upgrade) CONNECTORS - Internet/WAN: (1) RJ-11 (ADSL) port Network/LAN : (4) 10/100 Mbps Ethernet ports O/S SUPPORT - Windows 98/98SE/ME/2000/XP or Mac OS 9 or higher Linux/Unix (Mac & Linux/Unix not supported via USB port) PROTOCOLS - Supports RFC 2516 (PPPoE), 2364 (PPPoA) clients TCP, IP, UDP, NAT, PAT, DHCP (Client, Server) DNS (Client), TFTP (Client, Server) SMTP, POP3 VPN SUPPORT - L2TP, PPTP, IPSec (all pass-through) SECURITY - Denial of Service (DOS) protection IP Masquerading (NAT) Website blocking Web service blocking Internet activity logging SETUP & MANAGEMENT- Plug-n-Play install Web-based management SUPPORTED COMPUTERS- Maximum 253 REQUIREMENTS - PC or Macintosh with available Ethernet port or a PC with available USB port. Microsoft Windows 98, 98SE, Me, 2000, XP; Mac OS 9 or higher (USB: Windows 98, 98SE, Me, 2000, XP) TCP/IP network protocol installed Internet Explorer 4.0 + or Netscape 4.0 + APPROVALS - FCC C, UL, CE www.actiontec.com
|