Features

·         High efficiency

·         Low Ripple & Noise

·         Output over voltage protection

·         Short circuit protection on all outputs

·         Reset table power shut down

·         Approved by UL, TUV, CB & CE

·         INTERNAL 12 VDE fan

·         Complies with FCC part 15 subpart J Class B at 115VAC operation & CISPR 22 Class B at 230 VAC operation

·         100% burn-in under high ambient temperature (50¢J)

·         Vacuum-impregnated transformer

·         MTBF: 100K hours at 25¢J

·         100% Hi-pot tested

·        FULL RANGE 100~240VAC

Input Characteristics

·         Voltage: 95-132 VAC or 180-264 VAC switch able

·         Frequency: 47 Hz TO 63 Hz

·        Input current: 10 amps maximum/ 115 Vrms, 60 Hz. 5 amps maximum /230 Vrms, 50Hz.

Specification

·         Remote ON/OFF Control: The power supply shall accept a logic collector level, which will disable / enable all output voltage (excluding +5V standby).

·         Temperature range: operating 0¢J~50¢J, storage -20¢J ~ +80¢J

·         Temperature coefficient: 0.01% / ¢J

·         Transient response: output voltage recovers in less than 1 ms max. Following a 25% load change

·         Hold-up time: 16ms minimum at full load & nominal input voltage

·         Dielectric withstand: input / output 1800 VAC for 1 second, input to frame ground 1800VAC for 1 second

·         Humidity: 5~95% RH

·         Efficiency: 65% min. 70% typical, at full load

·         Power good signal: turn-on delay 100 ms to 500 ms

·         Overload protection: 150% max.

·         Inrush current: 60A cold, 80A ware at 132 VAC

·         Over voltage protection: +5V output: 6.5V; +3.3V output: 4.6V; +12V output: 15.5V